Z Impedance Calibrator – EBI100C/NICO100C
Impedance calibrator with 20 Ω reference and 50 Ω reference for the EBI100C, NICO100C, or NICO100C-MRI impedance amplifier.
ZCAL20 (20-ohm reference) and ZCAL50 (50 0hm reference) impedance calibrators plug into the EBI100C, NICO100C, or NICO100C-MRI via Touchproof pins.
- ZCALC is not compatible with the BioNomadix BN-NICO impedance amplifier or the NICO100D Smart Amplifier.
Calibration Procedure:
- Plug ZCAL20 into the front panel of the EBI100C, NICO100C, or NICO100C-MRI.
- Switch the EBI100C/NICO100C/NICO100C-MRI to the desired mode and confirm that the “Z” channel HP filter “DC” option is selected.
- Record data on “Z” or impedance channel.
- Press CAL1 in AcqKnowledge and then map the resulting voltage to “20 ohms.”
- Remove ZCAL20 and replace with ZCAL50.
- Press CAL2 in AcqKnowledge and then map the resulting voltage to “50 ohms.”
Are You Looking for These?
Part #: ZCALC
Details
Support
Applications
Downloads/Resources
- Methodological Guidelines for Impedance Cardiography, Sherwood et al, PSYCHOPHYSIOLOGY, Vol. 27, No. 1
- Signal Fidelity Requirements for Deriving Impedance Cardiographic Measures
- Psychophysiology article: Mathematical detection of aortic valve opening (B point) in impedance cardiography: A comparison of three popular algorithms
- Product Citations: review publications summary or conduct a search
Knowledge Base
- * CLEANING GUIDELINES *
- About License Keys
- AC mode
- AcqKnowledge accuracy
- AcqKnowledge iLok key lost or unavailable
- Amplifier analog output signals
- Amplifier filter settings
- Amplifier module filter response times
- Arbitrary waveform stimulation
- Band-pass and band-stop filters
- Bioimpedance Methods
- BioNomadix Signal Interruption
- Calculating file sizes
- Calibration values
- Checking Finger Cuff Lifetime for NIBP100D/NIBP100D-HD
- Common mistakes/general troubleshooting
- Connecting Calibration Gas Tanks & Mixing Chambers
- Differences between the NICO100C and EBI100C
- Editing noisy data
- Electrodermal activity measurements
- Event Markers | Correcting Automated Placement
- Excel files exported from BIOPAC software open in Excel 'Protected View'
- Glossary of specification terminology
- Grounding guidelines
- High pass filters
- How can I move QRS peak event marks from the bottom of S waves to the top of R waves?
- Installation CD/DVD lost or damaged...how can I re-install software?
- Interfacing third-party transducers
- Low pass filters
- Notch filter
- Railing signal (flatline)
- Recording good data
- Troubleshooting MP160 Ethernet Communication
- Using other software with BIOPAC hardware
- VREF, reference excitation voltage
Stay Connected