Tip of the 3.5 mm Jack goes to Pin 2 of the Analog Port (Low Voltage Stimulator Out).
The outer connector goes to pin 3 (GND).
The shield connects to ground on the DSub9 side.
Part #: OUT5
STMISOLA interface for MP36/36R
This DSUB9 to 3.5 mm mono jack interface allows the MP36/MP36R to be used with the STMISOLA Isolated Linear Stimulator for arbitrary stimulus output.
The 1 m interface connects the MP36/MP36R Analog Out port and the STMISOLA 3.5 mm Mono plug/cable.
Works with
- MP36 with BSL 4.1.2 or above
- MP36R with AcqKnowledge 4.4.2 or above
Details
Support
Application Notes
Downloads/Resources
Knowledge Base
- * CLEANING GUIDELINES *
- About License Keys
- AC mode
- AcqKnowledge accuracy
- AcqKnowledge iLok key lost or unavailable
- Amplifier analog output signals
- Amplifier filter settings
- Arbitrary waveform stimulation
- Band-pass and band-stop filters
- BioNomadix Signal Interruption
- Biopac Student Lab (BSL) Newest Features
- Calculating file sizes
- Calibration values
- Checking Finger Cuff Lifetime for NIBP100D/NIBP100D-HD
- Common mistakes/general troubleshooting
- Connecting Calibration Gas Tanks & Mixing Chambers
- Editing noisy data
- Electrodermal activity measurements
- Enabling the Transform Menu in BSL Analysis (RSD)
- Event Markers | Correcting Automated Placement
- Excel files exported from BIOPAC software open in Excel 'Protected View'
- Glossary of specification terminology
- Grounding guidelines
- High pass filters
- How can I move QRS peak event marks from the bottom of S waves to the top of R waves?
- Installation CD/DVD lost or damaged...how can I re-install software?
- Interfacing third-party transducers
- Low pass filters
- Notch filter
- Railing signal (flatline)
- Recording good data
- Troubleshooting MP160 Ethernet Communication
- Using other software with BIOPAC hardware
- VREF, reference excitation voltage
Stay Connected