Tap Interface for Airflow or Humidity
The AFT302 allows for a tap into a standard 22 mm ID airflow circuit to use a TSD302 temperature transducer or a TSD 304 humidity sensor to modify the values directly within the airflow stream. This tap may be used to measure and properly adjust values to STPD conditions. This unit is recommended for any users who require STPD corrections using the TSD302 temperature or the TSD304 humidity sensors.
Are You Looking for These?
Part #: AFT302
Categories: Airflow & Gas Analysis - Research
Subcategories: Accessories - Research, Tubing & Couplers - Research
Subcategories: Accessories - Research, Tubing & Couplers - Research
Details
Videos
Ventilator Validation System
Integrating BIOPAC Research Systems | Data Acquisition & Analysis
AcqKnowledge GUI Overview
Support
Downloads/Resources
Knowledge Base
- * CLEANING GUIDELINES *
- About License Keys
- AC mode
- AcqKnowledge accuracy
- AcqKnowledge iLok key lost or unavailable
- Amplifier analog output signals
- Amplifier filter settings
- Arbitrary waveform stimulation
- Band-pass and band-stop filters
- BioNomadix Signal Interruption
- Calculating file sizes
- Calibration values
- Checking Finger Cuff Lifetime for NIBP100D/NIBP100D-HD
- Common mistakes/general troubleshooting
- Connecting Calibration Gas Tanks & Mixing Chambers
- Editing noisy data
- Electrodermal activity measurements
- Event Markers | Correcting Automated Placement
- Excel files exported from BIOPAC software open in Excel 'Protected View'
- Glossary of specification terminology
- Grounding guidelines
- High pass filters
- How can I move QRS peak event marks from the bottom of S waves to the top of R waves?
- Installation CD/DVD lost or damaged...how can I re-install software?
- Interfacing third-party transducers
- Low pass filters
- Notch filter
- Railing signal (flatline)
- Recording good data
- Troubleshooting MP160 Ethernet Communication
- Using other software with BIOPAC hardware
- VREF, reference excitation voltage
Stay Connected