Accessories

Low flow resistance with high filtration efficiency Use this disposable bacteriological filter with integrated mouthpiece to protect subjects and equipment.…

This autoclavable mouthpiece connects directly to the TSD117/SS11LA airflow transducer and reduces the cost of disposable parts. (30 mm ID)…

This is a short chamber that is used when performing calibration of the GASSYS3 Gas Analysis module. The large chamber…

The AFT160 rigid 15 mm OD, 22 mm ID Pressure Tap coupler mates one connection with a 15 mm OD…

Use this NIST-certified manometer to calibrate the TSD160 series of differential pressure transducers. Range ±2 psi, ±140.6 cm H2O. The…

These disposable airlfow filters remove airborne bacteria; use with the TSD107B and other 35mm breathing circuits. AFT4 VBMax™ filters provide…

Disposable bacteriological filters for use with 22 mm breathing circuits, such as BIOPAC pneumotach transducers SS11LA, TSD117, or SS11. These filters…

These mouthpieces connect to the TSD117 pneumotach transducer and other 22 mm breathing circuits. Connects directly to the AFT1 bacterial…

These nose clips gently squeeze the nostrils shut to prevent errors when using mouth-breathing circuits. Available in packs of 10 or…

The RX-GAS3-GASKET is a set of endcap replacement gaskets for the GASSYS3 Gas Analysis Module. Over time the gaskets of…

The RX301 sensor has a response time of approximately 12 seconds for measuring changes in oxygen levels for air flow…

Use this gas sampling interface kit to connect the CO2100C or O2100C module with a variety of airflow breathing circuits. Use…

The AFT24 head support is useful when breathing directly into the AFT21 non-rebreathing T-valve for exercise physiology measurements. The AFT24…

Replacement pack of 10 hydrophobic filters for the AFT20 Gas Sampling Interface Kit. Use of Hydrophobic Filters (and Nafion Drying…

This inline coupler has a threaded port to fit the Galvanic Oxygen Sensor (RX301; included in TSD301) and ends that…

Replacement pack of 10 Nafion® drying tubes for the AFT20 Gas Sampling Interface Kit. Use of Nafion Drying Tubes (and Hydrophobic Filters)…

Use this Regulator Barb Interface with Luer lock to connect a regulator (such as GASREG) and GASCAL or GASCAL2 calibration…

Use the Regulator Barb Interface Kit to interface the GASCAL+GASREG calibration gas combination to an AFT15 mixing chamber to calibrate…

These mouthpieces connect to the TSD107B and other 35mm breathing circuits. Connects directly to the AFT4 bacterial filter or the…

The AFT302 allows for a tap into a standard 22 mm ID airflow circuit to use a TSD302 temperature transducer…

Use this 1.5 mm tubing with male and female Luer locks to interface with the RX110 self-inflating pressure pad or…