BIOPAC® Systems, Inc. Logo

Interface Nonin 9-pin to PPG100C

Request More Info
Nonin-interface-PPG100C
Part #: TCIPPG3

This interface connects all Nonin 9-pin transmissive and reflective optical probe transducers, or a range of other commercially available optical transducers for SpO2 (finger, toe, universal, and earclip), to the PPG100C Photoplethysmogram Amplifier.

The visible light transmitter and receiver of the probe is employed to establish a very high quality, high S/N ratio, transmissive, photo-plethysmogram signal, suitable for evaluating PPG signal characteristics. The snap on interface uses the Nonin gauge to generate a high-performance PPG type signal; the SpO2 signal is not measured.

The TCIPPG3 interface adapter plugs into the front of the PPG100C for MP Research Systems and allows it to work with SpO2-type probes that terminate in a 9-pin D female connector (such as those from Nonin®). The PPG100C also has the capability to interface to a wide range of commercially available optical probes. Probes are available for fingers, toes, earclip, and universal attachment. BIOPAC probes compatible with the TCIPPG3+PPG100C combination include the TSD124A, TSD124B and TSD124C. The TCIPPG3 also supports use of the OXY100E-200 extension cable.

See More...

Nonin PPG MP150 interface
View Spec PDF

Are You Looking for These?

Part #: TCIPPG3
Categories: Transducers - Research
Subcategories: Transducer Connector Interface - Research

Details

Compatibility


Note that this configuration does not provide SpO2 output, but rather a highly-detailed PPG waveform versus time.

Operational LED Current: 20 mA
Bandwidth: 0.05 Hz to 160 Hz (PPG100C performs upper band-limiting)
Connector: 9-pin DSub female
Interface: All Nonin 9-pin DSub sensors

This interface is not compatible with PPG100C-MRI.

Videos

AcqKnowledge GUI Overview

Focus Areas | AcqKnowledge Tutorial

Introduction to AcqKnowledge | Measurements

Support

Application Notes

Downloads/Resources

Knowledge Base

Recommended Items

Spotlight On
NIBP100E Amplifier ships with 3 finger cuffs

Noninvasive Blood Pressure Amplifier

The NIBP100E noninvasive blood pressure system provides continuous, beat‐to‐beat, blood pressure signal and values (Sys, Dia, MAP) and Pulse Rate (PR)*.  The NIBP100E amplifier with CNAP™ technology is controlled by AcqKnowledge software (v5.0.7) for MP160 Research Systems. The system outputs a continuous blood pressure waveform that is similar to a direct arterial pressure waveform. The amplifier […]

View All
Latest News

New Citations | The Limitlessness of Virtual Reality

BIOPAC provides software and hardware that allows research teams to conduct studies in virtual reality. Here are a few notable studies using both virtual reality systems and BIOPAC equipment researching to see how virtual reality could impact emotions, health, and medicine. Feelings on 2D vs. 3D Previous studies have suggested that virtual reality (VR) can […]

Electrocardiography Guide Now Available

BIOPAC’s comprehensive Introductory ECG Guide addresses fundamental to advanced concerns to optimize electrocardiography data recording and analysis. Topics include: ECG Complex; Electrical and Mechanical Sequence of a Heartbeat; Systole and Diastole; Configurations for Lead I, Lead II, Lead III, 6-lead ECG, 12-lead ECG, precordial leads; Ventricular Late Potentials (VLPs); ECG Measurement Tools; Automated Analysis Routines for extracting, […]

Read All
Request a Demonstration
Request a Demonstration