BIOPAC® Systems, Inc. Logo

BioNomadix Battery Charger

Request More Info
BioNomadix Battery Charger
Part #: BN-BAT-CHRG

The BioNomadix Battery Charger is a stand-alone +4.2 volt @ 1 amp charger that connects a BioNomadix Transmitter* module to mains power for charging. The BioNomadix Charger will charge a fully depleted BioNomadix transmitter module in approximately one hour. Full charge provides ~70-90 hours of operation for most module pairs.

Type: Lithium-Ion, single cell.
Output connector: Specific to BN-TX unit, subject leads lockout type connection.

The charger LED changes color to indicate a full charge.

  • Blinking – charging
  • Solid – fully charged
  • not illuminmated – check connections
See More...

Battery Charger for BioNomadix
View Spec PDF

Are You Looking for These?

Part #: BN-BAT-CHRG
Categories: BioNomadix Wireless Wearable Physiology - Research
Subcategories: Accessories - Research

Details

Compatibility


Transmitter batteries last 500 full charge/discharge cycles (70,000+ estimated operational hours) and are factory replaceable. For long term storage the transmitter should be fully charged and turned off before being stored for prolonged periods.

All BN series, wall plug-in, chargers are CE marked for the EC Low Voltage Directive and EMC Directive, and have one or more agency listed certifications (UL, CUL, CSA, GS, TUV and/or VCCI). The units have standard, modular/swappable, mains power input connections and operate over mains power ratings of 100-240 VAC, 50-60 Hz. Specify destination country when ordering.

One charger is included with each BioNomadix system. If you have multiple transmitter units, only one charger is needed. If simultanaeous charging or a charger backup is needed, additional chargers are recommended.

* For BioNomadix Loggers, use BN-LOG-CHRG (+5 volt @ 1amp).

Videos

Integrating BIOPAC Research Systems | Data Acquisition & Analysis

Support

Downloads/Resources

Knowledge Base

Recommended Items

Spotlight On
free BIOPAC webinar

Data Acquisition Fundamentals | Basic Training for the MP160 System

Learn how to maximize your BIOPAC data acquisition system and implement best practices for setting up and optimizing your MP System.

The presentation will cover the following:
• Demonstrate complete hardware and software setup
• Include details on how to incorporate commonly used amplifiers in the D-series, C-series, and BioNomadix
• Review legacy issues related to older system components and workarounds
• Show how to properly set up participants including proper lead options, electrode options, placement, and grounding/isolation procedures

Watch Live on February 10

Register Now
Latest News

New Citations | Does Smiling Make You Happier? & More

BIOPAC provides software and hardware that allows research teams to study any physiological measure. Here are a few notable studies using BIOPAC equipment for ECG, EDA, and HRV Analysis. Intelligent Interaction Leading to Solutions The research being done in the HCI space is amazing, as scientists continue to make computers more adept at communicating with humans, allowing more […]

Electrocardiography Guide Now Available

BIOPAC’s comprehensive Introductory ECG Guide addresses fundamental to advanced concerns to optimize electrocardiography data recording and analysis. Topics include: ECG Complex; Electrical and Mechanical Sequence of a Heartbeat; Systole and Diastole; Configurations for Lead I, Lead II, Lead III, 6-lead ECG, 12-lead ECG, precordial leads; Ventricular Late Potentials (VLPs); ECG Measurement Tools; Automated Analysis Routines for extracting, […]

Read All
Request a Demonstration
Request a Demonstration