If you have an existing amplifier or other piece of equipment that provides an analog signal in the ±10 volt range, you can connect the signal directly to the UIM100C by using one of the CBL100 series connection cables. We also offer signal isolators for those amplifiers that do not offer an isolated output. These analog signal isolators are used to connect mains powered external laboratory equipment to the MP System when the system also connects to electrodes attached to humans. For details on the safety and signal quality concerns, see Galvanic isolation guidelines for the MP150 system.
BIOPAC does make custom cables to interface with equipment that we do not have existing cables for. Consult your regional sales representative for further information about custom cable options.
The RSP Respiration Smart Amplifier is specifically designed for recording signals from a respiration transducer for direct physical measurement of respiratory effort. The amp works with the transducer to measure abdominal or thoracic expansion and contraction while breathing and permits DC coupling for the recording of respiratory effort signals of arbitrarily low frequency. BIOPAC’s new Smart […]
BIOPAC provides researchers with a complete range of tools to gather data on heart rate variability (HRV). The following studies demonstrate just some of the ways in which HRV research benefits from the implementation of BIOPAC hardware and software solutions. PTSD and HRV Post-traumatic stress disorder (PTSD) has been associated with dysfunction of the autonomic […]
BIOPAC’s comprehensive Introductory ECG Guide addresses fundamental to advanced concerns to optimize electrocardiography data recording and analysis. Topics include: ECG Complex; Electrical and Mechanical Sequence of a Heartbeat; Systole and Diastole; Configurations for Lead I, Lead II, Lead III, 6-lead ECG, 12-lead ECG, precordial leads; Ventricular Late Potentials (VLPs); ECG Measurement Tools; Automated Analysis Routines for extracting, […]