To interface a Gould transducer to BIOPAC hardware, you will need an interface cable from FOGG SYSTEM and a BIOPAC interface. Many BIOPAC interface options are supported. On the FOGG site, choose BIOPAC SYSTEMS as the “Monitor Manufacturer ” and then click the “Monitor Model” pop-down menu to see interface options (MP System interfaces are listed on the FOGG site, check the table below for BSL equivalents).
Interface
MP System
BSL System
Grass/Astromed (6 pin)
TCI100
BSL-TCI0
Beckman (5 pin)
TCI101
BSL-TCI1
WPI (8 pin)
TCI102
BSL-TCI2
Honeywell (6 pin)
TCI104
BSL-TCI4
Beckman (12 pin)
TCI106
BSL-TCI6
Nihon Koden (5 pin)
TCI107
BSL-TCI7
Fukuda (8 pin)
TCI109
BSL-TCI9
The fEMG Electromyography Smart Amplifier is designed specifically for recording facial EMG signals and electrical activity from other small muscle groups. Use with AcqKnowledge™ software to analyze facial expressions and startle paradigms. BIOPAC’s new Smart Amplifiers are designed for great data. Smart Amplifiers improve performance by amplifying the physiological signal close to the subject, which allows a high-level […]
View AllA System to Measure Physiological Response During Social Interaction in VR Children with Autism Spectrum Disorder (ASD) have a difficult experience in responding to social cues and actions. This pilot study measured the effectiveness of Virtual Reality in creating a social environment for children, measured with a BIOPAC MP Series data acquisition system and Worldviz […]
BIOPAC’s just released Introductory ECG Guide addresses fundamental to advanced concerns to optimize electrocardiography data recording and analysis. Topics include: ECG Complex; Electrical and Mechanical Sequence of a Heartbeat; Systole and Diastole; Configurations for Lead I, Lead II, Lead III, 6-lead ECG, 12-lead ECG, precordial leads; Ventricular Late Potentials (VLPs); ECG Measurement Tools; Automated Analysis Routines […]
Read All